LANEY LIONHEART L20H TUBE GUITAR AMPLIFIER HEAD CLASS A, 20W
LANEY LIONHEART L20H TUBE GUITAR AMPLIFIER HEAD CLASS A, 20W
Parallel single ended
Designed and engineered with pride in Great Britain, The LIONHEART L20H is a 20 watt Parallel, Single-Ended, Class 'A' all-tube head, giving a great range of clean, crisp, dynamic and open guitar tones. With less emphasis on preamp distortion, the L20H lets you hear and feel the power tubes clipping to breakup, giving a much richer harmonic content and a larger dynamic range. Play through a LIONHEART and you’ll be amazed at how it reacts to your touch.
Class A
From a guitarist point of view, in a class A amplifier each of the amplifiers power tubes are working at maximum output the whole time. This makes them run ‘HOT’ and generates a very natural level of smooth tube compression.
Parallel Single Ended
Higher powers are obtainable by using multiple valves in parallel – in this case 4 x EL84’s are run in Single ended mode and then paralleled up to give 20 watts RMS of Parallel Single Ended tone.
On-Board Reverb
On-board studio quality reverb. Reverb gives you a sense of the space that you are in. A dry guitar signal can sound a little dull. Adding the right about of reverb provides the guitar signal with ambience and brings it to life.
FX Loop
FX loops are important as they allow you to add effects to the signal path in a specific place between the pre-amp and the output section on an amplifier. This is where FX loops are important as it allows you to put time-based FX after the distorted pre-amp section. For example, delayed distortion sounds different to distorted delay – try it.
- Bright Switch
- 4, 8 or 16 Ohm impedance options
- Item dimensions: 253mm x 256mm x 253mm (HWD)
- Carton dimensions: 339mm x 719mm x 319mm (HWD)
- Item weight: 16.10kg
L20H
- Twin channel
- 20 watts RMS
- Parallel single ended class A valve tone
- FX Loop
- Passive bass, middle and treble EQ
- Bite switch and global tone control
- 3 x 12AX7 + 4 x EL84
- High quality digital reverb
- Supplied with custom embroidered slip cover
- FS2-mini footswitch included
- Dimensions (H x W x D): 260 mm x 570 mm x 260 mm
- Net weight: 16.1 kg
- LT212 cabinet sold separately
- L20-KIT as accessory